For the home
Petalo ruffled vase
Two smooth flutes turning together, opening into a scalloped rim that never settles level.
Personalisation available
Loading
Specifications
Dimensions
240 mm
Three heights: 150 mm, 200 mm and 240 mm. Round in plan, widest a little below the middle, and standing on the curve itself rather than on a foot.
Materials and finish
- Premium polymer — Designed and produced by the studio in polymer selected for the use, not for appearance alone.
- Matte, low-sheen surface — Finished to avoid a glossy plastic look and to keep fingerprints from reading.
Made for
A shelf, a dining table or a console, indoors, with a few upright dried or artificial stems — a slim glass insert when the flowers are cut.
Production and delivery
Made to order
Made in 3–7 working days from confirmation.
Delivery is on us within mainland Italy, up to €10 of carriage per order. Everything past that is quoted rather than assumed.
Provenance
Designed by ISPIRENZA in Italy, 2026
Produced in Italy
Use and care
- Indoors — Prolonged sun and frost change the material. This piece is made for indoors; an outdoor version can be produced in a different polymer, which is a design conversation rather than a substitution.
- Water and cut flowers — A printed wall is not sealed and is not watertight. Dried and artificial stems go straight in; cut flowers go into a slim glass or plastic insert dropped inside, never into the piece itself.
Save this page for later
Scan to return to this design on your phone.
Goccia teardrop vase
€55
per item
A fine, even relief runs over the whole wall, near enough to unglazed clay that people reach out to check. The mouth is small and cut square across the shoulder, so a few stems stand upright on their own. There is no foot — the curve runs unbroken to the table and takes the shadow with it. Three heights; cut flowers need a slim glass insert.
Quantity
Printed from
https://ispirenza.com/en/catalogue/goccia-teardrop-vase
One design, different uses
01 / 02
Living room
On a shelf, a sideboard or a low table, where it is seen every day.
Make this one yours
Tell us what should change about it — a name, a logo, a size, a colour — and we come back with a price and a date before anything is made.
How personalisation works
Send the brief
The change you describe, your dates and any reference file come to us with the design you were looking at.
We quote it
We check what the change involves, then send the price, the lead time and a proof of anything to be applied to the piece.
You approve, we make it
Nothing is produced until you have approved the proof and the total.
We normally reply within Within 24 hours.
When it has to exist
A real date changes what we can promise, so it is worth answering honestly.
What changes
Start with the closest suggestions, then tell us the part only you know.
The wording exactly as it should read, where it goes, what it is for. A voice note or a file counts instead of typing.
0 of 1200
Voice note(optional)
Recording stops automatically after 3 minutes.
Reference file(optional)
A logo, a sketch, a photograph of the thing it has to fit. PDF or image; a vector prints cleanest.
Drag files here, or
Images, PDFs and 3D files. Up to 4 files, 4 MB each.
How many with this change?
Parts we design and produce are made in polymer. Glass, metal, candles, electronics and hardware can be built into a piece as purchased components.
You might also like
For the home
Manto wrapped vase
One wall wound round the body and carried past itself at the top, where the two edges cross instead of meeting.
Personalisation available
For the home
Fiamma flame vase
Six flames overlapping up the body and separating at the top with open air between them.
Personalisation available
